Direct Waterjet™- Cutting of any material that can be cut by an erosive process. So... ANYTHING (non-toxic)
- Cutting area of 53"x53", with a table size of 70"x64"
- Excellent surface finish
- Precise to ±.005” is standard (±.003” after sample cuts have been made)
- Minimum taper on materials thicker than 1/4" thanks to our Tilt-A-Jet
- Exact placement on your substrate using our Omax Precision Optical Locator
- 3 grit options (80 HPX standard, 150 HPX Minijet standard, 220 HPX extremely fine edge) always on hand
- 5 different cutting qualities for minimizing expense and maximizing precision that can be mixed and matched on any part...
- Quality 1 - Used only when speed is of highest importance for very crude roughing out of parts. Lowest tolerance, highest speed. Not generally used.
- Quality 2 - General purpose roughing out of parts. Used when tolerance takes a back seat to speed.
- Quality 3 - Standard cutting quality. Good balance of edge quality and speed.
- Quality 4 - Better surface finish and corner compensation than Quality 3 at the sacrifice of speed.
- Quality 5 - Reserved for special cases when edge quality and precision are more important than speed.